lohasolo.blogg.se - Clear error message on lexmark printer x2670

121.30 Service Fuser Error Fuser failed to reach final temperature in time. 121.29 Service Fuser Error Attempting to print with estimated power at or above minimum power. 121.28 Service Fuser Error Fuser open thermistor check failed. 121.27 Service Fuser Error Fuser over temperature. 121.26 Service Fuser Error Attempting to print with estimated power at or below minimum power. 121.17 Service Fuser Error Total failure to close fuser nip. 121.16 Service Fuser Error Estimated power is at or above the maximum power. 121.15 Service Fuser Error Fuser shorted thermistor check failed for second thermistor.

121.14 Service Fuser Error Fuser shorted thermistor check failed for hot roll thermistor.

121.13 Service Fuser Error Fuser open thermistor check failed for second thermistor. 121.12 Service Fuser Error Fuser under temperature error while printing. 121.11 Service Fuser Error Fuser under temperature error while in standby. 121.10 Service Fuser Error Fuser failed to warm up. 121.07 Service Fuser Error Timed out waiting for home sensor event 121.08 Service Fuser Error Wrong lamp bit is set in NVRAM. 121.06 Service Fuser Error Attempting to print when the estimated power is too low. 121.05 Service Fuser Error Fuser failed to reach final temperature in time. 121.04 Service Fuser Error Attempting to print with estimated power at or above minimum power. 121.03 Service Fuser Error Fuser open thermistor check failed. 121.02 Service Fuser Error Fuser is over temperature.

Description: 121.01 Service Fuser Error Attempting to print with estimated power at or below minimum power.

Using a voltmeter, check the following values at JMIRR1: Pin 1: +5 V dc Pin 2: +3.3 V dc Pin 3: +5 V dc Pin 4: Ground Pin 5: +24 V dc Are the values approximately correct? Replace the controller board. Step 2 Turn the printer on, and then wait until the printer posts an error. Is the cable damaged? Replace the printhead. Check the cables at JMIRR1 and JPH1 on the controller board for proper connection, the printhead cable for pinch points, and the cable or connector for any other damage.

Remedy: Step 1 Turn the printer off, and then remove the rear cover.

110.13 Service Printhead Printhead declared error. 110.12 Service Printhead Failure reading data from the printhead. 110.11 Service Printhead Failure writing data to the printhead. 110.10 Service Printhead The printhead has bad SOS EOS measurement. 110.09 Service Printhead The printhead SOS EOS measurement did not complete. 110.08 Service Printhead The printhead laser showed bad in testing.

110.07 Service Printhead The printhead thermistor is shorted. 110.05 Service Printhead Failure reading NVRAM from printhead 110.06 Service Printhead The printhead thermistor is open. 110.04 Service Printhead The printhead mirror motors lost motor lock. 110.03 Service Printhead The printhead mirror motors lost motor lock.

Description: 110.01 Service Printhead he printhead lost HSYNC 110.02 Service Printhead The printhead failed to complete servo.